253
edits
Changes
no edit summary
=== DLM with Ct Clamps: ===
=== DLM with Ct Clamps: ===
This configuration is essential in the UK, where the use of CT clamps is mandatory for managing the electric load between chargers and other electronic devices. CT clamps facilitate compliance with UK regulations by enabling precise control and optimization of the overall load. Their integration into DLM systems ensures efficient energy distribution, essential for meeting the stringent energy standards and operational requirements set forth by UK energy authorities.
This configuration is advantageous in the UK, where the use of CT clamps is beneficial for managing the electric load between chargers and other electronic devices. CT clamps enable precise control and optimization of the overall load, contributing to compliance with UK regulations. Their integration into DLM systems assists in efficient energy distribution, which is important for adhering to the energy standards and operational requirements suggested by UK energy authorities.
[[File:Ct clamps.jpg|center|frameless|735x735px]]
[[File:Ct clamps.jpg|center|frameless|735x735px]]
== CT Connection ==
== CT Connection ==
[[File:MicrosoftTeams-image (33).png|alt=|frameless|left]]
[[File:MicrosoftTeams-image (33).png|alt=|frameless|left|[[File:Ct-meter.png|thumb]]]]
[[File:Ct-meter.png|center|frameless|349x349px]]
[[File:Ct-meter.png|center|frameless|331x331px]]
=== DLM with smart meter: ===
=== DLM with smart meter: ===
=== General CT settings ===
=== General CT settings ===
[[File:Ctapp.png|right|frameless|498x498px]]
1- By default, it is set to 3 seconds. However, there may be cases where the user needs to increase this value. For instance, if there are significant distances between the chargers and the ct clamps or if there are numerous interconnected chargers.
[[File:Ct.app.png|right|frameless|257x257px]]
# '''Measuring device''': The meter should be selected. For UK chargers, it is possible to choose CT clamps
# '''Energy meter address''': This information can be found in the meter settings accessed through the meter display. If the address cannot be located, it is recommended to consult the smart meter manual.
Note: before calibration, CT have to be connected to the port, but not clamped around the cable.
Note: Before calibration, CT have to be connected to the port, but not clamped around the cable.
=== How to calibrate CT: ===
1- Before calibration, CT have to be connected to the port, but not clamped around the cable.
2- Check DLB CT and press Calibrate.
3 - Success.
[[File:Dlbct.jpg|right|frameless|292x292px]]
