Difference between revisions of "Entes settings"
From Wiki
| Line 21: | Line 21: | ||
====How to configure Smart energy meter in mobile application==== | ====How to configure Smart energy meter in mobile application==== | ||
====''Note: Users could use two meters with different addresses. Additionally, there will be settings for these energy meters in the installer menu (these settings are the same for both energy meters).''==== | ====''Note: Users could use two meters with different addresses. Additionally, there will be settings for these energy meters in the installer menu (these settings are the same for both energy meters).''==== | ||
| − | 1. Make sure you have updated mobile application and firmware version of the charger to the latest. ( | + | 1. Make sure you have updated mobile application and firmware version of the charger to the latest. ([[Firmware]] and [https://apps.apple.com/lt/app/teltonika-energy/id1618750750 iOS] / [https://play.google.com/store/apps/details?id=com.teltonika.ems.ev&hl=en&gl=US Android]). |
2. Go to installer menu in your application and set general parameters from table above: | 2. Go to installer menu in your application and set general parameters from table above: | ||
[[file:General_meter_settings.png|alt=|left|frameless|205x205px]] | [[file:General_meter_settings.png|alt=|left|frameless|205x205px]] | ||
Latest revision as of 11:47, 3 September 2024
RS485 parameters for energy meter Entes ES-45LS
Note: Energy meter parameters should match EVSE default parameters.
| RS485 parameter | EVSE default parameter value (configurable in mobile app) |
|---|---|
| Modbus adress | 0-100* |
| Baud rate | 9600 |
| Parity | None |
| Stop bits | 1 |
- Entes meter factory default address is set by the last two digits of the serial number.
How to configure Smart energy meter in mobile application
1. Make sure you have updated mobile application and firmware version of the charger to the latest. (Firmware and iOS / Android).
2. Go to installer menu in your application and set general parameters from table above:
