|
|
| (3 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| − | ==Installation process==
| + | <li>[[Installation process|Physical installation process]]</li> |
| − | ===Housing Installation===
| + | → [[RCD - residual current device| RCD installation]] <br> |
| − | [[File:TeltoCharge Installation InstallationProcess DrillingA.png|border|frameless]]'''A''' - Place the drilling template on the wall and mark the three fixing points. | + | → [[SPD - surge protection device| SPD installation]] <br> |
| − | | |
| − | [[File:TeltoCharge Installation InstallationProcess DrillingB.png|border|frameless]]'''B''' - Drill holes where the fixing points are marked. | |
| − | | |
| − | [[File:TeltoCharge Installation InstallationProcess DrillingC.png|border|frameless]]'''C''' - Insert the wall plugs into the fixing holes. | |
| − | | |
| − | [[File:TeltoCharge Installation InstallationProcess HousingInstallation.png|border|frameless|214x214px]]
| |
| − | | |
| − | 1. Fix the device on the wall by inserting the self-tapping screws (start with the top screw and make sure the housing is horizontal).
| |
| − | | |
| − | 2. Make sure the cable gland is properly mounted on the cables (AC input cable and Ethernet cable).
| |
| − | | |
| | | | |
| | [[Category: Getting Started]] | | [[Category: Getting Started]] |
Revision as of 22:39, 30 March 2023
Main Page > TeltoCharge > Getting Started > Installation process
