Changes

|-

|-

|1.

|1.

|If Dynamic Load balancing is enabled

|How TeltoCharge sets maximum charging power when 3-phase charging is enabled?

|

|TeltoCharge checks which phase is loaded most, measures how much free current is available, and sets that current.

|-

|-

|2.

|2.

|Can I use simplified charging sequence with Dynamic load balancing.

|Can I use simplified charging sequence with Dynamic load balancing.

|Yes, there is possibility to use both features together, but there are some limitations which are regulated by the standard:

|Yes, there is possibility to use both features together, but there are some limitations which are regulated by the standard (IEC 61851-1 / SAE J1772):

# Maximum charging current is only 10 Ampers.

# Maximum charging current is only 10 Ampers.

|3.

|3.

|Can I use 3-phase smart meter for single phase charger?

|Can I use 3-phase smart meter for single phase charger?

|No, there is no possibility to use 1-phase charger with 3-phase smart meter.

|Yes, there is possibility to use 1-phase charger with 3-phase smart meter. Please refer to the Energy meter instruction sheet to configure it properly. It is required to select single phase meter in the TeltoCharge application settings.

|-

|-

|4.

|4.

|-

|-

|5.

|5.

|If phase priority is enabled, can charger automatically change phase?

|If "''use preferred phase''" is enabled, can charger automatically change phase?

|Yes, If TeltoCharge detects that prioritized phase is loaded and the maximum current it can give is 7 or less ampers, charger will make a check If other phases are loaded less:  

|Yes, If TeltoCharge detects that prioritized phase is loaded and the maximum current it can give is 7 or less ampers, charger will make a check If other phases are loaded less:  

* If there is other phase which is loaded less, charger will chnage charging phase.  

* If there is other phase which is loaded less, charger will change charging phase.  

* If other two phases ar loaded charger will stop charging process.

* If other two phases are loaded as well, charger will stop charging process.

|-

|-

|6.

|6.

|How TeltoCharge prioritizes phases when phase priority is disabled, TeltoChagre connected to three phases and three phase charging is disabled?

|How TeltoCharge prioritizes phases when phase priority is disabled, TeltoChagre connected to three phases and three phase charging is disabled? [[/]]

|Charger checks which phase is least loaded and selects that phase as a charging phase. If during charging process any of other two phases load decreases and the maximum available current will be 5 ampers higher then the charging phase, TeltoCharge will change charging phase to least loaded.

|Charger checks which phase is least loaded and selects that phase as a charging phase. If during charging process any of other two phases load decreases and the maximum available current will be 5 amperes higher then the charging phase, TeltoCharge will change charging phase to the least loaded. [[1]]

|}

|}