350
edits
Changes
Dynamic load balancing FAQ (view source)
Revision as of 06:11, 4 December 2023
, 06:11, 4 December 2023no edit summary
|3.
|3.
|Can I use 3-phase smart meter for single phase charger?
|Can I use 3-phase smart meter for single phase charger?
|No, there is no possibility to use 1-phase charger with 3-phase smart meter.
|Yes, there is possibility to use 1-phase charger with 3-phase smart meter. Please refer to the Energy meter instruction sheet to configure it properly. It is required to select single phase meter in the TeltoCharge application settings.
|-
|-
|4.
|4.
|Yes, If TeltoCharge detects that prioritized phase is loaded and the maximum current it can give is 7 or less ampers, charger will make a check If other phases are loaded less:
|Yes, If TeltoCharge detects that prioritized phase is loaded and the maximum current it can give is 7 or less ampers, charger will make a check If other phases are loaded less:
* If there is other phase which is loaded less, charger will chnage charging phase.
* If there is other phase which is loaded less, charger will change charging phase.
* If other two phases ar loaded charger will stop charging process.
* If other two phases are loaded as well, charger will stop charging process.
|-
|-
|6.
|6.
|How TeltoCharge prioritizes phases when phase priority is disabled, TeltoChagre connected to three phases and three phase charging is disabled? [[/]]
|How TeltoCharge prioritizes phases when phase priority is disabled, TeltoChagre connected to three phases and three phase charging is disabled? [[/]]
|Charger checks which phase is least loaded and selects that phase as a charging phase. If during charging process any of other two phases load decreases and the maximum available current will be 5 ampers higher then the charging phase, TeltoCharge will change charging phase to least loaded. [[1]]
|Charger checks which phase is least loaded and selects that phase as a charging phase. If during charging process any of other two phases load decreases and the maximum available current will be 5 amperes higher then the charging phase, TeltoCharge will change charging phase to the least loaded. [[1]]
|}
|}