541
edits
Changes
mLine 44:
Line 44: − + Line 73:
Line 73: − + Line 79:
Line 79: − + Line 85:
Line 85: − + + + + − + Line 94:
Line 97: + + + + + + + + Line 114:
Line 125: + + + + +
no edit summary
=Device info=
=Device info=
In this tab user/installer can see all the HW information about charger, maximum current set by installer (inside installer menu) and real-time temperature.
In this tab user/installer can see all the HW information about charger, maximum current set by installer (inside installer menu) and real-time temperature. Also there is possibility to restore default settings. With this function TeltoCharge restors all settings to default values except for installer menu.
By pressing chek for updates it opens new window, where user/installer can see information about current FW.
By pressing chek for updates it opens new window, where user/installer can see information about current FW.
==Upper voltage tolerance==
==Upper voltage tolerance==
There is ability to change the tolerance limit for upper voltage. This can be used in the sites where voltage fluctuation is big.
There is possibility to change the tolerance limit for upper voltage. This can be used in the sites where voltage fluctuation is big.
==Lower voltage tolerance==
==Lower voltage tolerance==
There is ability to change the tolerance limit for lower voltage. This can be used in the sites where voltage fluctuation is big.
There is possibility to change the tolerance limit for lower voltage. This can be used in the sites where voltage fluctuation is big.
==Three phase charging==
==Three phase charging==
-
With this slider installer have ability to turn off 3-phase charging if 3 phases are connected.
''By default this setting is turned off''
==Phase priority==
==Phase priority==
There is ability to select which phase should be prioritized for charging, if 3 phases are connected, but 3-phase charging is disconnected. For example if 3 chargers are connected to the same electric network, there is ability to prioritize different phase for each charger to avoid power cut off.
There is possibility to select which phase should be prioritized for charging, if 3 phases are connected, but 3-phase charging is disconnected. For example if 3 chargers are connected to the same electric network, there is ability to prioritize different phase for each charger to avoid power cut off.
==Dynamic load balancing==
==Dynamic load balancing==
This function is used to turn on Dynamic load balancing. To access this feature it is recommended to read more [[Dynamic Load Balancing|here]]
''By Default this setting is turned off''
==Use preferred phase==
==Use preferred phase==
This function can be used if dynamic load balancing is on. With this feature installer can set to use preffered phase for charging process.
''By default this setting is turned off''
==Allow simplified charging sequence==
==Allow simplified charging sequence==
''By default this setting is set to 60 °C''
''By default this setting is set to 60 °C''
== Factory default settings ==
By using theese settings installer have ability to restore factory default settings. This function restores all settings which were set in the installer menu and in the main menu.
After this reset yellow LED's starts blinking which means that charger requires to set-up installer menu again.
=Reboot device=
=Reboot device=
There is possibility to reboot charger through the Teltonika Energy app.
There is possibility to reboot charger through the Teltonika Energy app.