Line 40: |
Line 40: |
| 1- By default, it is set to 3 seconds. However, there may be cases where the user needs to increase this value. For instance, if there are significant distances between the chargers and the ct clamps or if there are numerous interconnected chargers. | | 1- By default, it is set to 3 seconds. However, there may be cases where the user needs to increase this value. For instance, if there are significant distances between the chargers and the ct clamps or if there are numerous interconnected chargers. |
| # '''Measuring device''': The meter should be selected. For UK chargers, it is possible to choose CT clamps | | # '''Measuring device''': The meter should be selected. For UK chargers, it is possible to choose CT clamps |
− | # '''Energy meter address''': This information can be found in the meter settings accessed through the meter display. If the address cannot be located, it is recommended to consult the smart meter manual. | + | # '''Energy meter address''': This information can be found in the meter settings accessed through the meter display. |
− | | + | # If the address cannot be located, it is recommended to consult the smart meter manual. |
| + | [[File:Calibrate-ct.jpg|right|frameless]] |
| Note: Before calibration, CT have to be connected to the port, but not clamped around the cable. | | Note: Before calibration, CT have to be connected to the port, but not clamped around the cable. |
| | | |
| === How to calibrate CT: === | | === How to calibrate CT: === |
− |
| |
− |
| |
| | | |
| 1- Before calibration, CT have to be connected to the port, but not clamped around the cable. | | 1- Before calibration, CT have to be connected to the port, but not clamped around the cable. |
| | | |
| 2- Check DLB CT and press Calibrate. | | 2- Check DLB CT and press Calibrate. |
− | [[File:Calibrate-ct.jpg|right|frameless|304x304px]]
| + | |
| 3 - Success. | | 3 - Success. |