Installation

Installation manual

AC INPUT SPECIFICATIONS
	7,4 kW	11 kW	22 kW
Input AC power connection	1 phase	3 phases	3 phases
Input voltage	22 to 240 VAC	380 to 415 VAC	380 to 415 VAC
Rated frequency	50 / 60 HZ
Standby power consumption	4 W
Earth (ground) fault protection	30 mA AC, 6 mA DC
Overvoltage category	CAT III
Protection against electric shock	Class I
AC Output specifications
AC output voltage range	220 - 240V AC	380 - 415V AC	380 - 415V AC
Connection Standart	Type 2 cable Type 2 socket

Model	E V C
Version	1
Power	7,4 kW 11 kW 22 kW
Connector	Socket Tethered cable
Connectivity	Without GSM modem With GSM modem
Front plate color	Grey Red Blue White N/A
Front finish

A	Flying debris, risk of injury
B	Risk of electric shock
C	Caution
D	Sharp elements, risk of injurious cuts
E	Special waste treatment

A - Place the drilling template on the wall and mark the three fixing points

B - Drill holes where the fixing points are marked.

C - Insert the wall plugs into the fixing holes.

1. Fix the device on the wall by inserting the self-tapping screws (start with the top screw and make sure the housing is horizontal).

2. Make sure the cable grommet is properly mounted on the cables (AC input cable and Ethernet cable). LED indicators

A	Yellow - LEDs pulsing - First start. Default settings have not changed.
B	White - LEDs pulsing - Standby.
C	Blue - LEDs light up from the middle - Waiting for car to initiate charging.
D	Blue - LEDs light up from top to bottom - Charging is scheduled. A schedule has been set by the user.
E	Green - all LEDs are on - Charging is complete.
F	Yellow - all LEDs pulsing - Simplified charging sequence is denied, do not charge and contact your installer.
G	Green - LEDs pulsing - Initialization of charging.
H	Green - all LEDs are up upwards from the bottom - Charging is in process.
I	Red - LEDs pulsing - Faulty connection to car.

troubleshooting