Carlo Gavazzi settings: Difference between revisions

Revision as of 10:04, 27 August 2026

RS485 parameters for energy meter Carlo Gavazzi series 1; series 2; series 3

Note: Energy meter parameters should match EVSE default parameters.

RS485 parameter	EVSE default parameter value (configurable in mobile app)
Modbus adress	1
Baud rate	9600
Parity	None
Stop bits	1

Configuring the meter in the mobile application

Note: Users can use two meters with different addresses. Additionally, there will be settings for these energy meters in the installer menu (these settings are the same for both energy meters).

1. Make sure your charger firmware and application are updated to the latest version. (←Release notes: Firmware and iOS / Android).

2. Enter the Installer menu, select Load Balancing, then Modbus RTU.

3. If the charger does not recognize the meter, go to Manual Setup to use a device preset or enter the settings from the RS485 parameters table manually.

For detailed settings, refer to the energy meter's official documentation.

← Smart energy meters

@@ Line 30: / Line 30: @@
 . Make sure your charger firmware and application are updated to the latest version. (←[[Release notes: Firmware]] and [https://apps.apple.com/lt/app/teltonika-energy/id1618750750 iOS] / [https://play.google.com/store/apps/details?id=com.teltonika.ems.ev&hl=en&gl=US Android]).
-. Enter the installer menu, select Load Management or Load Balancing, then the communication type of the meter.
+. Enter the Installer menu, select Load Balancing, then Modbus RTU.
-. If the charger recognizes the meter, you can "Search for device". Otherwise, in Manual Setup, use a device preset or enter the settings from the RS485 parameters table manually.
+. If the charger does not recognize the meter, go to Manual Setup to use a device preset or enter the settings from the RS485 parameters table manually.