Carlo Gavazzi settings: Difference between revisions

Revision as of 08:35, 27 August 2026

RS485 parameters for energy meter Carlo Gavazzi series 1; series 2; series 3

Note: Energy meter parameters should match EVSE default parameters.

RS485 parameter	EVSE default parameter value (configurable in mobile app)
Modbus adress	1
Baud rate	9600
Parity	None
Stop bits	1

Configuring the meter in the mobile application

Note: Users can use two meters with different addresses. Additionally, there will be settings for these energy meters in the installer menu (these settings are the same for both energy meters).

1. Make sure your charger firmware and application are updated to the latest version. (←Release notes: Firmware and iOS / Android).

2. Enter the installer menu, select Load Management or Load Balancing, then the communication type of the meter.

3. If the charger recognizes the meter, you can "Search for device". Otherwise, in Manual Setup, use a device preset or enter the settings from the RS485 parameters table manually.

For detailed settings, refer to the energy meter's official documentation.

← Smart energy meters

@@ Line 23: / Line 23: @@
 |}
-==== How to configure Smart energy meter in mobile application ====
+==== Configuring the meter in the mobile application ====
-''Note: Users could use two meters with different addresses. Additionally, there will be settings for these energy meters in the installer menu (these settings are the same for both energy meters).''
+''Note: Users can use two meters with different addresses. Additionally, there will be settings for these energy meters in the installer menu (these settings are the same for both energy meters).''
-. Make sure you have updated mobile application and firmware version of the charger to the latest. (←[[Firmware]] and [https://apps.apple.com/lt/app/teltonika-energy/id1618750750 iOS] / [https://play.google.com/store/apps/details?id=com.teltonika.ems.ev&hl=en&gl=US Android]).
+. Make sure your charger firmware and application are updated to the latest version. (←[[Release notes: Firmware]] and [https://apps.apple.com/lt/app/teltonika-energy/id1618750750 iOS] / [https://play.google.com/store/apps/details?id=com.teltonika.ems.ev&hl=en&gl=US Android]).
-. Go to installer menu in your application and set general parameters from table above:
+. Enter the installer menu, select Load Management or Load Balancing, then the communication type of the meter.
-[[file:General_meter_settings.png|alt=|left|frameless|]]
+. If the charger recognizes the meter, you can "Search for device". Otherwise, in Manual Setup, use a device preset or enter the settings from the RS485 parameters table manually.
+For detailed settings, refer to the energy meter's official documentation.
-. To get data form energy meter, you will need to set the energy meter address in the “Dynamic load balancing” section:
-[[file:Dynamic_load_balancing.png|alt=|left|frameless|]]
-. Also, you will need to set the kWh meter address in the “Meter for power consumption calculation” section if you want to use it:
-[[file:Meter_for_power_consumption_calculation.png|alt=|left|frameless|]]
-To find out specific settings, you will need to read the energy meter's documentation.
 ← [[Smart energy meters]]