Functionalities EVC2: Difference between revisions
| (3 intermediate revisions by the same user not shown) | |||
| Line 7: | Line 7: | ||
='''NEW:''' Physical power selector switch= | ='''NEW:''' Physical power selector switch= | ||
* This switch is found on the interface board. | * This switch is found on the interface board. | ||
* It could be turned to limit MAX device output. By changing rotary switch position it is possible to | * It could be turned to limit MAX device output. By changing rotary switch position it is possible to change charger’s max output. | ||
* By default (position 0) charger sets max possible output power depending on HW. | * By default (position 0) charger sets max possible output power depending on HW. | ||
* Possible values differ between different modification devices.[[File:Power selector switch.png|thumb|none]] | * Possible values differ between different modification devices.[[File:Power selector switch.png|thumb|none]] | ||
| Line 53: | Line 53: | ||
* Meter port will be used for load balance and MID meter. | * Meter port will be used for load balance and MID meter. | ||
* DLM port used only for load management. | * DLM port used only for load management. | ||
* Dynamic Load | * Dynamic Load Management with MID meter for all of the secondary devices is '''possible''' | ||
* | * | ||
[[File:2x RS.png|frameless]] | [[File:2x RS.png|frameless]] | ||
| Line 93: | Line 93: | ||
For example: you set 32 A in Installer menu option '''Max power from grid''', so in user menu option '''Load balancing''' you will be able to set limitation from 6 A to 32 A. | For example: you set 32 A in Installer menu option '''Max power from grid''', so in user menu option '''Load balancing''' you will be able to set limitation from 6 A to 32 A. | ||
''By default load balancing is set to 10 A, user can increase this value when | ''By default load balancing is set to 10 A, user can increase this value when they increase Max power from grid option in Installer menu.'' | ||
= Schedule = | = Schedule = | ||
| Line 169: | Line 169: | ||
*''PIN code'' | *''PIN code'' | ||
*''APN | *''APN address'' | ||
*''Username'' | *''Username'' | ||
*''Password'' | *''Password'' | ||
| Line 248: | Line 248: | ||
==Three phase charging== | ==Three phase charging== | ||
With this slider installer have an ability to turn | With this slider installer have an ability to turn on 3-phase charging (only if 3 phases are connected to the product). | ||
| Line 278: | Line 278: | ||
==Temperature warning== | ==Temperature warning== | ||
There is a possibility to increase temperature warning level. When charger reaches this temperature level, it starts to ventilate itself by decreasing charging power. If Charger reaches | There is a possibility to increase temperature warning level. When charger reaches this temperature level, it starts to ventilate itself by decreasing charging power. If Charger reaches 8''5°C'' it turns off relays and stops charging process. | ||