Difference between revisions of "Inepro settings"

Revision as of 08:20, 10 March 2023

Note: Energy meter parameters should match EVSE default parameters.

RS485 parameter	EVSE default parameter value (configurable in mobile app)
Modbus adress	1
Baud rate	9600
Parity	Even
Stop bits	1

@@ Line 1: / Line 1: @@
-← [[Smart energy meters]]
 ==== RS485 parameters for energy meter Inepro PRO380-Mod  ====
 ''Note: Energy meter parameters should match EVSE default parameters.''
@@ Line 22: / Line 21: @@
 |}
-==== How to configure Smart energy meter in mobile application ====
-''Note: Users could use two meters with different addresses. Additionally, there will be settings for these energy meters in the installer menu (these settings are the same for both energy meters).''
-. Make sure you have updated mobile application and firmware version of the charger to the latest. (←[[Firmware]] and [https://apps.apple.com/lt/app/teltonika-energy/id1618750750 iOS] / [https://play.google.com/store/apps/details?id=com.teltonika.ems.ev&hl=en&gl=US Android]).
-. Go to installer menu in your application and set general parameters from table above:
-[[file:General_meter_settings.png|alt=|left|frameless|]]
-. To get data from energy meter, you will need to set the energy meter address in the “Dynamic load balancing” section:
-[[file:Dynamic_load_balancing.png|alt=|left|frameless|]]
-. Also, you will need to set the kWh meter address in the “Meter for power consumption calculation” section if you want to use it:
-[[file:Meter_for_power_consumption_calculation.png|alt=|left|frameless|]]
-To find out specific settings, you will need to read the energy meter's documentation.
-← [[Smart energy meters]]